hecho amanoCraft Supplies and Workshops

All you need for Rubber Stamping, Scrapbooking and Paper crafts in Almeria

   Tel: 950 391 226
info@hechoamano-almeria.com

Hexagonal Santa And Rudolf

You will need:-

  • “Dear Santa” Clear stamp set FRCL072

  • Green 14cm square card

  • Black pigment ink, clear embossing powder & heat gun

  • Large circle of red sparkle card

  • Small piece of black card

  • Small piece of white card

  • 2 plain peel-off corners

  • Straight edge peel-off borders

  • Greeting peel-off

  • White pencil

  • 1mm & 2mm sticky foam pads

  • Double sided tape

  • Large and small circle punches (2½ & 1½cm)

  1. Measure and mark 4cm from each corner along all four sides (8 in all).

  2. Join these dots by drawing a line across each corner and cut away. You should now have your hexagonal card. Gently rub away any remaining pencil marks.

  3. Decorate the edges with the peel off border.

  4. Emboss the Santa and reindeer heads plus two mittens on the white card.

  5. Colour and then carefully cut out. (When cutting out the images leave a very small white border otherwise the embossing may crack away).

  6. Now to make the Santa. Cut a small straight piece to make the belt, and attach approximately two thirds down the round body with double sided tape.

  7. Make a buckle with the two plain corners.

  8. Punch two large circles and one small circle from the remaining black card.

  9. Cut a straight line off the bottom of the two large circles and a small V shape out of the smaller circle.

  10. Attach the body with double sided tape to the bottom slightly right of the card. Make sure you leave enough room for the heads and feet.

  11. Attach the two large circles to the bottom of the body to make the feet, flat side down.

  12. Attach as shown the heads, mittens and hoof to the body with 1mm and 2mm pads.

  13. Carefully draw a shine mark on shoes and reindeer hoof as shown.

  14. Stick on your greeting and you’re done!